← Каталог
Барои калон кардан курсорро ба болои тасвир баред
594
Centre drills without flat
Centre drills without flat. Designation: Centre drills without flat, Diameter range: 1.190 mm – 7.940 mm, TABLE_INFO_PASSON: [{"attr":"P","val":"full"},{"attr":"M","val":"partial"},{"attr":"K","val":"full"},{"attr":"N","val":"full"},{"attr":"S","val":"partial"},{"attr":"H","val":"-"}], EAN: 4031093183444, Cutting material: HSS, Surface: bright, Type: N, Standard: ASME B94.11M, Point angle: 118, Cutting direction: Right-hand, Form: A
Мушаххасоти техникӣ
- EAN
- 4031093183444
- Form
- A
- Type
- N
- Surface
- bright
- Standard
- ASME B94.11M
- Designation
- Centre drills without flat
- Point angle
- 118
- Diameter range
- 1.190 mm – 7.940 mm
- Cutting material
- HSS
- Cutting direction
- Right-hand
- TABLE_INFO_PASSON
- [{"attr":"P","val":"full"},{"attr":"M","val":"partial"},{"attr":"K","val":"full"},{"attr":"N","val":"full"},{"attr":"S","val":"partial"},{"attr":"H","val":"-"}]
Андозаҳо ва рамзҳои фармоиш
| Рамзи фармоиш | Flute length | Total length | Shank diameter | Nominal diameter | Мавҷудият | Дархости нарх |
|---|---|---|---|---|---|---|
| 594 7.940 | 34.00 mm | 89.00 mm | 19.05 mm | 7.94 mm | Тибқи дархост | |
| 594 3.170 | 19.00 mm | 54.00 mm | 7.94 mm | 3.17 mm | Тибқи дархост | |
| 594 1.980 | 11.00 mm | 48.00 mm | 4.76 mm | 1.98 mm | Тибқи дархост | |
| 594 6.350 | 29.00 mm | 83.00 mm | 15.88 mm | 6.35 mm | Тибқи дархост | |
| 594 4.760 | 23.00 mm | 70.00 mm | 11.11 mm | 4.76 mm | Тибқи дархост | |
| 594 2.780 | 15.00 mm | 51.00 mm | 6.35 mm | 2.78 mm | Тибқи дархост | |
| 594 1.190 | 9.00 mm | 32.00 mm | 3.18 mm | 1.19 mm | Тибқи дархост | |
| 594 5.560 | 27.00 mm | 76.00 mm | 12.70 mm | 5.56 mm | Тибқи дархост |